How to glue Background in the corners: instructions, gluing outer, inner corner, docking

Step-by-step instructions to gluing inner corners

When finishing, the principal problem can be uneven walls and the resulting springs on the wallpaper. It’s also necessary to take into consideration that as soon as the walls are crooked, the joints of wallpaper canvases might invisibly.

After gluing the previous one in the front of the interior corner of the cloth must measure the remaining space. It is measured from the border of the glued cloth to the adjoining wall, so the resulting amount is inserted 10-15 millimeters. If the partitions are very curved, then the extra figure may be .

Cut a strip equivalent to the resulting figure, taking into consideration the allowance. The surfaces have been treated with glue. Depending on the type of coat it may be just the wall or both surfaces.

The strip is then glued independently using the cut gidpola.ru side into the wall. The background should go on the other airplane.

If the glued wallpaper is wrinkled, you need to make several smallish cuts perpendicular to the folds.

Level or incline on the adjacent wall is a perpendicular lineup. The distance from the corner is equal to the diameter of the preceding cut strip, not adding developments.

The surfaces are smeared with glue, and the coat is glued to the wall with the flat side to the marked line. The cut goes on the adjacent wall.

Protruding corner ought to be pasted by analogy with an interior, but there are small gaps, which also need to be taken into account when working.

Measured the space remaining from the glued background to the adjoining wall. Add 20-25 millimeters to the got figure.

A segment is cut off, taking into account the additional 20-25 millimeters.

Prior to gluing, the surfaces have been treated with glue.

The even edge has to be glued to the wallpaper fixed on the wall, the own cut facet”goes” into the adjacent plane. If needed, small cuts are made in the area of going to the other background, smoothed and pressed to the wall.

Draw a vertical strip on the adjoining wall at a distance of just glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is placed on the wall using its flat side towards the marked line, going over the edge of the glued strip.

The joints have been smeared with glue and ironed using a roller. After that, the upper layer is cut across the ruler and the two layers are combined together.

Leave a Reply

Your email address will not be published. Required fields are marked *

1 + twelve =